WMF SKYLINE 3200000005 Instrucciones De Uso página 7

Safety instructions
▪ Only connect the device to properly installed earthed sockets. The wire and plug must be dry.
▪ Do not pull the connecting cable over sharp edges or clamp it. Do not let it hang down and protect
it from heat and oil.
▪ Never disconnect the mains plug from the socket by the cord or with wet hands.
▪ Stop using the appliance and/or connect it from the mains plug immediately if:
⋅
The appliance or mains cable is damaged;
⋅ the device is not leak-proof;
⋅ there is any suspicion of a fault after dropping the appliance or similar.
In such cases, send the appliance to be repaired.
▪ Do not place the kettle on hot surfaces, such as hot plates or similar, or near open flames. It could
melt.
▪ Do not place the device on water-sensitive surfaces. Water spray may damage them.
▪ Do not operate the device under delicate furniture. Escaping steam from boiling could damage the
furniture.
▪ Never operate the kettle unattended.
▪ Do not switch on the device without water.
▪ Take the pot for filling from the base.
▪ Only fill with clean water, not milk, coffee, etc.
▪ Do not move the device during operation and do not pull on the mains cable.
▪ Caution: the device is hot. Risk of scalding from escaping steam. Only take hold of the hot kettle from
the handle and do not open the lid when pouring.
▪ Always completely empty the pot. Do not let any residual water remain in the device for a long
period of time.
▪ The mains plug is to be pulled:
⋅
if malfunctions occur during use,
⋅
before cleaning and care,
⋅
after use.
▪ No liability is accepted for any damages resulting from misuse, incorrect operation or improper
repairs.
Claims under warranty are likewise excluded in such cases.
▪ Packaging material, such as plastic film bags, do not belong in the hands of children.
Start-up
Prior to first use, clean the kettle thoroughly from the inside. To do so, open the lid by pressing the
button on the handle.
A mesh filter is fitted in the spout to hold back large limescale and calcium deposits when pouring out
the water.
The section of the power cable not in use can be wound up and stored on the underside of the base.
Connect the power plug to a shockproof socket.
Fill in at least so much water that the water level is visible on the water level indicator, but no higher
than the max mark. Close the lid. Only then will the automatic boiling stop work reliably.
Set the kettle on the base facing in any direction. Only then push the ON switch under the handle
downwards.
When using the kettle for the first time, do not use the boiled water for preparing food or beverages.
7