Kärntner Str. 18-30 • D-42327 Wuppertal; Www.wAlther-Pilot.dE • Email: Info@Walther-Pilot.dE; Normal Use; 10 352 - WALTHER PILOT PILOT III F-HD Instrucciones De Servicio

Contents
1 General
1.1 Identification of Model Version
1.2

Normal Use

1.3 Improper Use
2 Safety Instruction
3 Technical Description
4 Connection of Input Lines
5 Operational Handling
6 Adjusting the Spray Pattern
7 Correcting the Spray Pattern
8 Replacement of the Spray Gun Components
8.1 Replacement of material nozzle and air cap
8.2 Replacement of the needle
8.3 Replacement of needle seal packing
9 Cleaning
10 Waste disposal
11 Technical Data
1 General
1.1 Identification of Model Version
Models: Manual Spray Guns PILOT III F-HD, III F-MD, III K
Type: PILOT III F-HD Gravity-Feed Cup
PILOT III F-HD Material Connection
PILOT III F-HD Syphon-Feed Cup
PILOT III F-MD Gravity-Feed Cup
PILOT III F-MD Material Connection
PILOT III K Gravity-Feed Cup
PILOT III K Material Connection
Manufacturer: WALTHER Spritz- und Lackiersysteme GmbH

Kärntner Str. 18-30 • D-42327 Wuppertal

Telefon: *202 / 787-0 • Telefax: *202 / 787-217

www.walther-pilot.de • Email: info@walther-pilot.de

1.2 Normal Use
The manual spray guns of the series PILOT III F-HD and -MD are designed to be
used exclusively for sprayable media, such as:
• paints and lacquers
• greases, oils and corrosion preventives
• ceramic glazes
• stains
Since the wetted parts aren't made of stainless specialty steel, aggressive materi-
als shoudn't be sprayed.
The manual spray guns of the series PILOT III K are designed to be used for
adhesives.
If the material you intend to spray is not included in the above list, please contact
WALTHER Spritz- und Lackiersysteme GmbH, Wuppertal, for further information.
Please note that sprayable materials may only be applied to workpieces and /or
similar objects.
The temperature of the spraying material must not exceed 43°C.
The term "normal use" also implies that all safety warnings, operating handling
details, etc., as stated in these operating instructions are carefully read, under-
stood and duly complied with.
This equipment complies with the explosion protection requirements of Directive
94/9/EC (ATEX 100a) for the explosion group, equipment category and temperatu-
re class indicated on the type plate. When using the equipment, the requirements
specified in these Operating Instructions must be observed at all times.
V 10 301
V 10 302
V 10 303
V 10 310
V 10 311
V 10 351
V 10 352
2