Using The Converter - Waeco PerfectCharge DC08 Instrucciones De Montaje

_DC Power Booster.book Seite 27 Mittwoch, 11. April 2007 8:31 08
PerfectCharge / PerfectPower
6.2 Mounting the converter
➤ Hold the converter against the installation location and mark the fastening
points (fig. 3 A, page 3).
➤ Fasten the converter using your chosen method (fig. 3 B, page 3).
7

Using the converter

Connecting the input battery
Warning!
Do not reverse the polarity. Reverse polarity of the battery
connections can cause injury and irreversably damage the device.
Note
Tighten the nuts or bolts to a torque of 12 – 13 Nm. Loose
connections may cause overheating.
➤ Set the main switch (fig. 1 6, page 3) to "0f".
➤ Lay the positive cable (fig. 1 7, page 3) from the converter to positive
terminal of the battery and connect it.
➤ Lay the negative cable (fig. 1 8, page 3) from the converter to negative
terminal of the battery and connect it.
Connecting the output load to the converter
➤ Loosen the screw (fig. 4 2, page 4) in the positive terminal (fig. 4 4,
page 4).
➤ Push the cable lug (fig. 4 3, page 4) of the positive cable on the output
load into the positive terminal (fig. 4 4, page 4) and fasten it with the
screw (fig. 4 2, page 4) and the split washer (fig. 4 1, page 4).
➤ Connect the negative cable of the output load in the same way to the
negative terminal (fig. 4 5, page 4).
Using the converter
27