Maintenance, Technical Data, Development, Contact - Biogents BG-GAT Manual De Instrucciones

Maintenance
1. Check the trap regularly and change the water at least
once a month. Attention: If it is dry, the water can
evaporate quickly. Make sure that there is enough water
in the trap at all times.
2. Remove any debris that falls into the trap or deters the
mosquitoes from entering the trap.
3. Make sure the barrier net does not hang into the water. If it
does, tighten it as described under the chapter "Assembling
the Trap"point 5 above. Empty, clean, and refill the bucket.
This will destroy larvae or pupae that may have developed.
Info:
The BG-GAT is dishwasher safe (up to 158° F/70° C).
Technical Data
Weight: 1.3 lbs / 0.6 kg
Dimension: 10.6 x 15.2 in / 27 x 38.5 cm
Development
The BG-GAT trap was developed by Dr. Á.E. Eiras from the Universidade Federal de Minas Gerais, Belo Horizonte,
Brazil and Prof. Scott Ritchie from the James Cook University, Cairns, Queensland, Australia.
Contact
Biogents AG
Weißenburgstr. 22
93055 Regensburg
Germany
www.biogents.com
E-mail: sales@biogents.com
8 EN
4. Avoid the development of larvae by either
• emptying, cleaning, and refilling the bucket weekly
or by
• adding the biological larvicide Bti ("mosquito
dunks" and similar products). About 1/4 Bti
mosquito dunk each month in the bucket with water
will be sufficient.
5. Replace the sticky card when it is full or does not stick
anymore because of accumulated dust.
Further information about the BG-GAT can be found on our
webpage www.biogents.com
Mosquito Control