OHAUS Scout Serie Manual De Instrucciones página 6

EN-4
VIRTUAL PORT SOFTWARE INSTALLATION
1. Insert the supplied CD into the CD drive.
Different versions of Windows® have slightly different steps to load the driver
that is on the CD. In all versions the New Hardware Wizard guides you
through the required steps to select the driver that is located on the CD.
Example of Windows XP Hardware Wizard
You may also get the latest drivers from this link:
http://www.ftdichip.com/Drivers/D2XX.htm
2. After clicking Finish, the virtual port should be ready for use.
Windows® typically adds the virtual port in sequence after the highest number
COM port. For example, on PC's equipped with up to 4 COM ports, the virtual
port will be COM5.
When using the USB interface with programs that limit the number of COM port
designations, it may be necessary to assign one of these port numbers to the new
virtual port. This can be done in the Port Settings of the Device Manager utility,
found in the Windows Control Panel.
USB DEVICE OUTPUT
With the interface installed the balance will operate in several ways according to
the settings.
Print format can be switched by xFMT user command.
USB Device Interface