Loading The Washer - Haier HLP21N Manual Del Usuario

Steps for the Wash Process
1.
Turn the power ON by pressing the "ON" button.
2. Press "Cycle Select"to select wash program.
3. Select the water level.
4. Add the detergent.
5. Add the wash load.
6. Press the Start / Pause button.
i
7. After the wash ng mach ne
turning OFF the machine and then restarting to make the new selection.
Note: If the washer is turned ON without any water in the tub, it will start to
spin after a few minutes. The pulsator will not rotate unless the water is
filled to a selected level.
Note: Do not use the "HEAVY Wash" program for woolen clothing.

Loading the Washer

Note:
• Load each item loosely.
• Separate the white from the colored clothing. Separate heavy fabrics from light
fabrics.
• Carefully check all pockets and cuffs for foreign items. They can easily slide
into the tub and cause damage to the tub and/or make disturbing noises during
cycles.
• Always balance the laundry load evenly within the washer tub, so there is no
single heavy areas and all the laundry is evenly distributed.
Note:
There is a filter in the water inlet valve. This prevents foreign particles in
the water from entering the washer. Clean this at least once a month.
Selecting the Water Level
• There are 3 pre-set water levels to chose from: Low, Medium and High
.
Your selection may depend on your
ＭＥＤＩＵＭ
i starts, you may change the cylcle or program by
wash load
ＷＡＴＥＲ
ＬＥＶＥＬ
ＨＩＧＨ
ＬＯＷ
English
16