3.2
Use the buttons on control pad to operate the massage seat cover:
Operation
•
Switch on the device by pressing On/Off button
illuminates.
•
When the "Upper Back" massage button
next to the button illuminates and the Shiatsu massage heads
move from the "Park" position at the base of the backrest, up to the
shoulder area, massaging the back in a circular motion whilst doing
so. Once the uppermost position has been reached, the direction of
rotation of the massaging heads is reversed. The heads then travel
down to the centre of the back. Once the heads reach this point, the
direction of rotation is reversed again and then travel up the back
again. If you press button
switched off and the massage heads remain stationary in their cur-
rent position.
•
If you press the "Lower Back" massage button
the button illuminates. The Shiatsu massage heads
down the lower half of the back in a circular motion. The reversal of
the direction of rotation takes place when the respective end posi-
tions are reached. Pressing button
off this function and the massage heads remain stationary in their
current position.
•
If you press the "Full Back" massage button
dure is similar to pressing buttons
entire back.
•
During the Shiatsu massage you may press the buttons
activate the spot massage. You can adjust the massage heads with
the arrow buttons.
•
Rolling massage: A rolling massage is like a massage with two
hands working up and down your back. To use this function, press
the button
tensity). A second press on the button
= high intensity).
•
While the unit is in Rolling massage mode for the back, press button
r
press, the massage heads will move to the next available position.
•
To activate the Shiatsu massage, press button
to the button lights up (1 = low intensity). A second press on the but-
ton
•
You can enhance the Shiatsu massage at any time with a vibration
massage for your thighs by pressing the vibration massage button
t
. The LED "1" next to the button lights up (1 = low in-
6
to adjust the distance between the massage heads. With each
increases the intensity (2 = high intensity).
5
.
9
during the massage, this function is
9
during the massage, switches
q
and
, except that it is for the
9
q
increases the intensity (2
6
3 Operating
. The power LED
4
is pressed, the LED
, the LED next to
q
travel up and
1
the function proce-
0
or
7
8
. The LED "1" next
5
GB
1
to
17