Maintenance And Cleaning - GALA Sensitive Smart Manual De Instruccion

MAINTENANCE AND CLEANING

hard
ANOMALIES DETECTION
If you have any anomaly in the bathtub, do
not allow anyone to intervene in its interior,
except the technical assistance service. Verify
the following anomalies table, and if
necessary contact a GALA distributer.
No function is activated
Remote control retro illumination
58
ANOMALY
The auto-cleaning cycle
does not initiate
The maintenance heater
of the water temperature
does not maintain the
temperature
Remote control does not
activate
does not turn on
Bathtub does not respond
to the remote control's
orders
neutral
soft
POSSIBLE CAUSE
Energy failure
The differential switch or the
thermo magnetic relay was
triggered
Water level too low
Motor damaged or obstructed
Misregulated level sensor
Lack of disinfectant liquid
(see informative screen)
Wrong selection of
a function
Safety thermostat
discharged
Discharged batteries
Discharged batteries
Remote control is not
synchronized with the bathtub
SOLUTION
Make sure there is power in the
house
Put the switches in the position
of closed circuit (ON)
If it triggers again, do not turn it
on again; contact your distributor
Fill above the uppermost jet
Contact your distributor
Contact your distributor
Refill the correspondent tank
with disinfectant liquid
Press the function selection key
for more than 3 seconds
Contact your distributor
Switch batteries
Switch batteries
Synchronize remote