Rotorbike POWER RPM1 Manual De Usuario página 27

"D"
1.a) SpACER VERIFICAtION FOR ROAD CRANKS
For correct use of your ROTOR Power road cranks it is
necessary to select the appropriate spacers for your
frame.
NOtE: If different BB/bearing is used, spacing may
differ.
Select your frame and spacers from the list below:
1. bb30 frame: Place one "D" spacer (11,5mm) in
drive side and one "D" spacer in non-drive side.
2. pressfit30 frame: Place one "D" spacer (11,5mm) in
drive side and one "D" spacer in non-drive side.
3. bbright frames: Place one "D" spacer (11,5mm) in
drive side.
USER MANUAL - ROAD CRANK INSTALLATION
Di
W
W 68mm 68mm 79mm
42mm (Direct fit) /
Di 42mm 46mm
46mm (PressFit)
4. bSA frame: Place one BSA30 cup (L) in non-drive
side and one BSA30 cup (R) in drive side of the
frame.
5. ItA frame: Place one ITA30 cup in non-drive side
and one ITA30 cup in drive side of the frame.
6. bb86 frame: Place one PF4130 cup in non-drive
side and one PF4130 cup in drive side of the frame.
7. 386 frame: Place one PF4630 cup with an "A"
spacer (2,5mm) in non-drive side and one PF4630
cup with an "A" spacer in drive side of the frame.
("A" spacers not included, visit your ROTOR
distributor)
Read your bottom bracket manual to verify the
compatibility with your frame.
68mm 70mm 86,5mm 86mm
BSA ITA 41mm 46mm
ES
EN
27