Rotorbike POWER RPM1 Manual De Usuario página 28

"D"
"C"
"B"
1.b) SpACER VERIFICAtION FOR Mtb CRANKS
For correct use of your ROTOR Power MTB cranks it is
necessary to select the appropriate spacers for your
frame.
NOtE: If different BB/bearing is used, spacing may
differ.
Select your frame and spacers from the list below:
1. bb30 and pressfit30 68mm frames: Place one "C"
(8,5mm) spacer with one "D" (11,5mm) spacer in
drive side and non-drive side.
2. bb30 and pressfit30 73mm frames: Place one "b"
(5,5mm) spacer with one "D" (11,5mm) spacer in
drive side and non-drive side.
28
USER MANUAL - MTB CRANK INSTALLATION
Di
W
W 68/73mm 68/73mm 84mm
Di 42mm 46mm 46mm
3. bbright frame: Place one PF4630 cup with one "b"
(5,5mm) spacer in non-drive side and one PF4630
cup with one "D" spacer (11,5mm) and one "b"
(5,5mm) spacer in drive side.
4. bSA 68mm frame: Place one BSA30 cup with one
"C" (8,5mm) spacer in both sides of the frame.
5. bSA 73mm frame: Place one BSA30 cup with one
"b" (5,5mm) spacer in both sides of the frame.
6. bb89 and bb92 frames: Place both PF4130 cups
with one "b" (5,5mm) spacer in both sides of the
frame.
Read your bottom bracket manual to verify the
compatibility with your frame.
68/73mm 89,5mm 92mm
BSA 41mm 41mm