DeWalt DW076 Manual De Instrucciones página 10

Láser rotativo
Ocultar thumbs Ver también para DW076:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Slide the battery pack in firmly until you hear the battery pack
lock in place.
REMOVING THE BATTERY PACK
1. Push the battery in slightly, press the release buttons, and firm-
ly pull the battery pack out of the receptacle.
2. The battery ejector pin (B) will aid in removing the pack.
3. To recharge the battery pack, insert it into the charger as
described in the charger section of this manual.
Control Panel
The laser is controlled by the ON/OFF button (C) and the manual
rotation button (D). Three indicator lights are on the control panel,
power LED light (E), X-axis leveling (F), and Y-axis leveling (G).
TURNING THE LASER ON
1. Insert the fully charged battery pack through the proper cut out
in battery adapter plate. Be sure that the battery is firmly
engaged.
2. Gently press the ON/OFF button (C) to power the laser on.
The laser diode will turn on and the power LED light (E) will
illuminate. The X-axis and Y-axis leveling lights (F, G) will
flash indicating that the laser is automatically leveling.
NOTE: The head will only rotate momentarily if the laser is leveling.
The head will begin or resume rotation once the laser is level.
E F G
C
TURNING THE LASER OFF
Gently press the ON/OFF button to turn the laser off. The power
LED Light will no longer be illuminated.
Using the Laser on a Tripod
1. Position the tripod securely and set it to the desired height.
2. Make sure that the top of the tripod is roughly level. the laser
will self-level only if the top of the tripod is within ± 5˚ of level.
If the laser is set up too far out of level, it will beep when it
reaches the limit of its leveling range. No damage will be done
to the laser, but it will not operate in an "out of level" condition.
3. Secure the laser to the tripod by screwing the threaded knob on
the tripod into the female thread on the bottom of the laser.
NOTE: Be sure that the tripod you are working with has a 5/8"–11
threaded screw to ensure secure mounting.
4. Turn the laser on by pressing the ON/OFF button (C). The
rotary head starts to spin after the unit levels itself.
Using the Laser in Level Mode
The laser can be positioned directly on the floor or on a tripod
(described above) for applications such as carpentry.
1. Place the laser on a smooth surface where it will not be
disturbed.
2. Position the laser for level setting as shown.
3. Turn the laser on by pressing the ON/OFF button (C).
4. The level indicator lights (F, G) blink on and off until the rotary
head is level.
5. The rotary head starts spinning after leveling and the indi-
cator lights remain on continuously.
NOTE: When the laser is out of leveling range. The rotary head
D
stops spinning, the laser turns off, the transmitter beeps and
the level indicator lights (F, G) blink.
8

Publicidad

Tabla de contenido
loading

Tabla de contenido