Important Charging Notes - DeWalt DW076 Manual De Instrucciones

Láser rotativo
Ocultar thumbs Ver también para DW076:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

battery life. The red light flashes long, then short while in the Hot
Pack Delay mode.
PROBLEM POWER LINE
Some chargers have a Problem Power Line indicator. When the
charger is used with some portable power sources such as genera-
tors or sources that convert DC to AC, the charger may temporarily
suspend operation, flashing the red light with two fast blinks fol-
lowed by a pause. This indicates the power source is out of limits.
LEAVING THE BATTERY PACK IN THE CHARGER
The charger and battery pack can be left connected with the red
light glowing indefinitely. The charger will keep the battery pack
fresh and fully charged.
NOTE: A battery pack will slowly lose its charge when kept out of
the charger. If the battery pack has not been kept on maintenance
charge, it may need to be recharged before use. A battery pack
may also slowly lose its charge if left in a charger that is not plugged
into an appropriate AC source.
WEAK BATTERY PACKS: Chargers can also detect a weak bat-
tery. Such batteries are still usable but should not be expected to
perform as much work. In such cases, about 10 seconds after bat-
tery insertion, the charger will beep rapidly 8 times to indicate a
weak battery condition. The charger will then go on to charge the
battery to the highest capacity possible.

Important Charging Notes

1. Longest life and best performance can be obtained if the bat-
tery pack is charged when the air temperature is between 65°F
and 75°F (18°- 24°C). DO NOT charge the battery pack in an
air temperature below +40°F (+4.5°C), or above +105°F
(+40.5°C). This is important and will prevent serious damage to
the battery pack.
2. The charger and battery pack may become warm to touch
while charging. This is a normal condition, and does not
indicate a problem. To facilitate the cooling of the battery pack
after use, avoid placing the charger or battery pack in a warm
environment such as in a metal shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other
appliance
b. Check to see if receptacle is connected to a light switch
which turns power off when you turn out the lights.
c. Move charger and battery pack to a location where the
surrounding air temperature is approximately 65°F - 75°F
(18°- 24°C).
d. If charging problems persist, take the tool, battery pack and
charger to your local service center.
4. The battery pack should be recharged when it fails to produce
sufficient power on jobs which were easily done previously. DO
NOT CONTINUE to use under these conditions. Follow the
charging procedure. You may also charge a partially used pack
whenever you desire with no adverse affect on the battery pack.
5. Under certain conditions, with the charger plugged into the
power supply, the exposed charging contacts inside the charg-
er can be shorted by foreign material. Foreign materials of a
conductive nature such as, but not limited to, steel wool, alu-
minum foil, or any buildup of metallic particles should be kept
away from charger cavities. Always unplug the charger from the
power supply when there is no battery pack in the cavity.
Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WARNING: Shock hazard. Don't allow any liquid to get inside
charger. Electric shock may result.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido