Kicker KB6 Manual Del Propietário página 3

Use the mounting bracket as a template to mark the mounting
holes on the mounting surface. Make sure there is adequate
room to tighten the locking knobs on both sides of the
mounting bracket before you pre-drill the mounting holes. Use
a 7/64" (2.5mm) drill bit when using the supplied black coated
stainless steel mounting screws, then screw the mounting
bracket to the mounting surface.
3
B
3
B
1
Unscrew the locking knobs on both
sides of the speaker mounting bracket.
included
screws
3
A
2
Position the KB6 enclosure, loosely
fasten the locking knobs, adjust
the angle of the speaker and then
tighten the locking knobs once you
have the desired listening angle.
If the supplied hardware is not applicable
to your installation, some other means
of securely attaching the speakers to
the vehicle or mounting location must be
used. The threaded inserts on the top,
bottom and back of the KB6 are 1/4"-
20 (.25 inches in diameter, 20 threads
per inch), and may be used with other
mounting systems to customize your
installation. You are solely responsible for
securely fastening the enclosure.
3