Dometic GROUP Waeco MagicSpeed MS880 Instrucciones De Montaje página 77

MagicSpeed MS880
Using the original clutch switch
Cut off the two-pin plug from the green/white and purple cable.
Connect the purple cable with the original clutch switch cable, whose
signals change when you apply the clutch pedal.
The purple cable can process the following changes:
– Connect to earth
– From earth to ∞
– From earth to +12 V
– From +12 V to earth
Insulate the green/white cable.
This cable is not required when using an original clutch switch.
Twisted cable pair (blue and blue/white)
NOTE
I
Both these cables are only connected when there is a CAN bus
connection.
They are not required for analogue connection. In this case,
insulate the ends and store them.
Do not mix up the cables. Otherwise the cruise control will not
function.
Connect the blue cable (P3) to CAN high.
Connect the blue/white cable (P2) to CAN low.
NOTE
I
For a CAN bus connection, all cables in the cable set are now con-
nected. You can now install the control element, see chapter "In-
stalling the control element (accessory)" on page 84.
In this case, insulate the ends of the remaining four cables and
store them.
EN
Connecting the electrical power to MagicSpeed
77