Installing The Control Element (Accessory) - Dometic GROUP Waeco MagicSpeed MS880 Instrucciones De Montaje

Installing the control element (accessory)

9 Installing the control element
(accessory)
A number of different control elements are available, depending on your
requirements.
Control element MS-BE3
NOTE
I
When selecting the installation location, observe the following
instructions:
Make sure the driver does not have to reach through the steering wheel
to use the control element.
Install the control element
– where it can be safely used at all times,
– on the dashboard or centre panel.
NOTICE!
A
Before drilling holes, make sure the drill bit will not damage any-
thing on the other side (fig. 2, page 4).
Select a suitable installation location (fig. 6, page 5).
Drill a 6 mm hole near the control element.
Guide the cable of the control element through this hole to the cable of the
cruise control.
Push the connection cable of the control element into the compact plug.
Plug the connection cable of the control element into the 8-pin housing.
Plug the assembled 8-pin compact plug of the control element into the
8-pin socket of the cable set.
MS-BE4 control lever
Control lever MS-BE4 is supplied with its own assembly instructions.
Read the instructions carefully before installation.
84
MagicSpeed MS880
EN