Synchronising With An Analogue Connection; Starting Setup Mode - Dometic GROUP Waeco MagicSpeed MS880 Instrucciones De Montaje

MagicSpeed MS880
12 Synchronising with an analogue
connection
NOTE
I
Before you can configure the settings, you must switch the system
to analogue connection.
12.1 Switching MagicSpeed to analogue connection
Press and hold the SW1 button on the rear of the electronic module.
Switch on the ignition.
You will hear two high-pitched signals.
Let go of the SW1 button.
Press the RES button on the control element.
The electronic module is switched from the "CAN bus connection" setting
to the "Analogue connection" setting.
When the switchover is complete, you will hear four high-pitched signals.
Switch the ignition off.
12.2

Starting setup mode

NOTE
I
To begin one of the adjusting and teach modes you must always
carry out the following procedure.
For automatic mode (page 96), you first have to start the motor.
For any of the other modes, you first simply have to switch the
ignition off and on again.
To start setup mode, proceed as follows:
Depending on the mode, do one of the following:
– For automatic mode: start the motor.
– For the other modes: switch the ignition off and on again.
Press the ON/OFF button on the control element.
Apply the brake within one minute and hold it down.
EN

Synchronising with an analogue connection

91