Makita DGA405 Manual De Instrucciones página 10

Installing or removing depressed
center wheel or multi disc (optional
accessory)
WARNING:
• When using a depressed center wheel or multi
disc, the wheel guard must be fitted on the tool
so that the closed side of the guard always
points toward the operator.
• Only actuate the shaft lock when the spindle is
not moving.
► 1. Lock nut 2. Depressed center wheel 3. Inner
flange
Mount the inner flange onto the spindle.
Make sure to fit the dented part of the inner flange onto
the straight part at the bottom of the spindle.
Fit the wheel/disc on the inner flange and screw the lock
nut onto the spindle.
1
2
► 1. Lock nut wrench 2. Shaft lock
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
To remove the wheel, follow the installation procedure
in reverse.
Installing or removing flex wheel
(optional accessory)
WARNING:
• Always use supplied guard when flex wheel is
on tool. Wheel can shatter during use and guard
helps to reduce chances of personal injury.
1
2
3
► 1. Lock nut 2. Flex wheel 3. Plastic pad 4. Inner
flange
Follow instructions for depressed center grinding wheel/
Multi-disc but also use plastic pad over wheel. See
order of assembly on accessories page in this manual.
Installing or removing abrasive disc
(optional accessory)
► 1. Sanding lock nut 2. Abrasive disc 3. Rubber pad
Mount the rubber pad onto the spindle. Fit the disc on
the rubber pad and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
NOTE:
• Use sander accessories specified in this man-
ual. These must be purchased separately.
10 ENGLISH
1
2
3
1
2
3
4