Makita DGA405 Manual De Instrucciones página 9

ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing side grip (handle)
CAUTION:
• Always be sure that the side grip is installed
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard (For
depressed center wheel, multi disc /
abrasive cut-off wheel, diamond wheel)
WARNING:
• When using a depressed center grinding wheel/
Multi-disc, flex wheel, wire wheel brush, cut-off
wheel or diamond wheel, the wheel guard must
be fitted on the tool so that the closed side of the
guard always points toward the operator.
• When using an abrasive cut-off / diamond
wheel, be sure to use only the special wheel
guard designed for use with cut-off wheels.
For tool with clamp lever type wheel guard
1
2
► 1. Wheel guard 2. Bearing box 3. Screw 4. Lever
Loosen the lever on the wheel guard after loosening the
screw. Mount the wheel guard with the protrusion on the
wheel guard band aligned with the notch on the bearing
box. Then rotate the wheel guard to such an angle that
it can protect the operator according to work.
2
1
► 1. Screw 2. Lever 3. Wheel guard
Tighten the lever to fasten the wheel guard. If the lever
is too tight or too loose to fasten the wheel guard,
loosen or tighten the screw to adjust the tightening of
the wheel guard band.
To remove wheel guard, follow the installation proce-
dure in reverse.
For tool with locking screw type
wheel guard
1
2
► 1. Wheel guard 2. Bearing box 3. Screw
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard to such an angle that it
can protect the operator according to work. Be sure to
tighten the screw securely.
To remove wheel guard, follow the installation proce-
dure in reverse.
3
4
9 ENGLISH
3
3