Descargar Imprimir esta página

Know Your Unit - Poulan Pro PPB32SST Manual De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

KNOW Y OUR U NIT
READ
THIS INSTRUCTION
MANUAL
AND S AFETY
RULES
BEFORE
OPERATING
YOUR
UNIT
Compare the illustrations with your unit to familiarize yourself with the location of the various controls
and adjustments.
Save this manual for future reference.
Assist
Handle
Shaft
ON/OFF
Switch
Trimmer
Head
_
Starter Handle
Shield
Primer Bulb
Throttle
Trigger
Line Umiter
Blade
ON/OFF
SWITCH
The ON/OFF
switch
is located on the trigger
handle and is used to stop the engine. Move the
switch to the OFF position to stop the engine.
PRIMER
BULB
The PRIMER BULB removes
air from the car-
buretor and fueI lines and fills them with fuel.
This allows you to start the engine with fewer
pulis on the starter rope. Activate
the primer
bulb by pressing
it and allowing
it to return to
its original form.
Start Lever
Muffler
START
LEVER
The START LEVER helps to supply fuel to the
engine to aid in starting. Activate
the starting
system by moving the start lever to the START
position. DO NOT squeeze
the throttle trigger
until the engine has started and runs. After the
engine starts, allow the engine to warm-up
5
seconds, then fufly squeeze
the throttle trigger
to deactivate the starting system.
BEFORE
STARTING
ENGINE
_f_,WARNING:
Be sure to read the fuel
information
in the safety rules before you be-
gin. If you do not understand
the safety rules,
do
not
attempt
to
fuel
your
unit.
Call
1-800-554-6723.
FUELING
ENGINE
_
WARNING:
Remove fuel cap slowly
when refueling.
HELPFUL
TIP
To ebtain the correct eil mix
I
t ratio,
pour 3.2 ounces
of
I
2-cycle
synthetic
oil into
I
one gallon of fresh gas.
I
This
engine
is certified
to operate
on un-
leaded
gasoline,
Before
operation,
gasoline
must be mixed with a good quality
synthetic
2-cycle
air-cooled
engine oil designed
to be
mixed at a ratio of 40:1. Poulan/WEED
EATER
brand synthetic
oil is recommended.
Mix gas-
oline and oil at a ratio of 40:1, A 40:1 ratio is
obtained
by mixing 3.2 ounces
(95 ml) of oil
with
1 gallon (4 liters) of unleaded
gasoline.
DO NOT USE automotive
oi$ or marine
oil.
These
oils wilt cause engine damage.
When
mixing fuel, follow instructions
printed on con-
tainer.
Once oil is added to gasoline,
shake
container
momentarily
to assure that the fuel
is thoroughly
mixed.
Always
read and follow
the safety rules relating to fuel before fueling
your unit.
IMPORTANT
Experience
indicates
that alcohol
blended
fuels
(called
gasohol
or using
ethanol
or
methanol)
can attract moisture which leads to
separation
and formation
of acids during stor-
age. Acidic gas can damage
the fuel system
of an engine while in storage.
To avoid engine
problems,
empty the fuel system before stor-
age for 30 days or tonger. Drain the gas tank.
start the engine and let it run until the fuel lines
and carburetor
are empty. Use fresh fuel next
season.
Never
use
engine
or
carburetor
cleaner
products in the fuel tank or permanent
damage
may occur.
See the STORAGE
section for additional
in-
formation.
HOW
TO STOP
YOUR
UNIT
• To stop the
engine,
move
the ON/OFF
switch
to the OFF position.
4

Publicidad

loading