Poulan Pro PPB32SST Manual De Instrucciones página 8

Bend the line a tthe midpoint and insert
the bend into t he slot inthe center rim of
the spool. Ensure line s naps into p osition
inthe slot.
7. With y our finger between the lines, wrap
thelines e venly and firmly a round the
spool inaclockwise direction.
8. Position the lines inthe guide slots.
Guide Slot
Guide
Slot
\
9. Insert the ends of the lines through exit
holes in the sides of the cover.
10. Place the spool in the cover.
Cover
11. Make sure the lines are not caught be-
tween the rim of the spool and the wall of
the cover.
12. Reinstall the spool and cover onto the
trimmer head. Push until cover snaps into
place.
REPLACING THE CUTTING HEAD
1. Align t_ole in the dust cup with the ho_e in
the side of the gearbox by rotating the
dust cup.
2. Insert a small screwdriver into aligned
holes. This will keep the shaft from turning
while removing and installing trimmer head.
Screwdriver__
3. While holding the screwdriver in position,
remove trimmer head by turning clock-
wise.
4. Thread replacement trimmer head onto
the shaft by turning counterclockwise.
Tighten until secure.
5. Remove the screwdriver.
CARBURETOR ADJUSTMENT
WARNING: Keep
others away when
making idle speed adjustments, The trimmer
head, blade or any optional attachment will be
spinning during most of this procedure. Wear
your protective equipment and observe all safe-
ty precautions, After making adjustments, the
trimmer head, blade or any optional attachment
must not move/spin at idle speed.
The carburetor has been carefully set at the
factory, Adjustments may be necessary if you
notice any of the following conditions:
• Engine will not idle when the throttle is
released.
• The trimmer head. blade or optional
attachment moves/spins at idle.
Make adjustments with the unit supported so
the cutting attachment is off the ground and
will not make contact with any object. Hold
the unit by hand while running and making ad-
justments. Keep all parts of your body away
from the cutting attachment and muffler.
Idle Speed Adjustment
Allow engine to idle. Adjust speed unti_ engine
runs without trimmer head, blade or optional
attachment moving or spinning (idle too fast)
or stalling (idle speed too slow).
• Turn idle speed screw clockwise to
increase engine speed if engine stalls or
dies.
• Turn idle speed screw counterclockwise to
decrease engine speed if trimmer head.
blade or optional attachment moves or
spins at idle.
WARNING; Recheck the idle speed
after each adjustment. The trimmer head.
blade or optional attachment must not move
or spin at idle speed to avoid serious injury to
the operator or others.