Removing The Mounting Brackets; Troubleshooting The Installation - Lucent Technologies 300584935 Manual De Uso

Removing the Mounting Brackets

Perform the following procedure to remove the Patch Panel Piggyback Mounting
Brackets from the chassis and patch panel.
Removing the Mounting Brackets
Begin
End

Troubleshooting the Installation

If you experience a problem with your PSAX Multiservice Media Gateway sys-
tem, refer to the Lucent Technologies Product Warranty Registration Information,
which accompanied your PSAX product shipment, for instructions on obtaining
support in your area.
The information in this document is for informational use only, is subject to change without notice, and should not be
construed as a commitment by Lucent Technologies, Inc. This document is without warranty of any kind, either ex-
pressed or implied. Lucent Technologies, Inc. assumes no responsibility for any errors, inaccuracies, or omissions. Nei-
ther is any liability assumed for damages resulting from the use of the information or instructions contained herein.
Lucent Technologies, Inc. is not responsible for any damage or loss to your data or equipment resulting either directly
or indirectly from use of this document.
Lucent Technologies has made a commitment to reduce the environmental impact of its products by reusing and recy-
cling material. In keeping with this commitment, this document is printed on paper containing 80% recycled paper
with 60% post-consumer waste. We encourage you to support the principle of reduction, reuse, and recycling of ma-
terials by recycling this product when it is no longer needed.
Copyright © 2003 Lucent Technologies
All rights reserved. Printed in the USA.
Part Number: 706M0A0001Z1
1 Remove the PSAX 1000 chassis from the Wall Mounting Plate by removing
the four nuts and washers holding the chassis to the mounting plate.
2 Lay the chassis in an upright position on a table.
3 With a Phillips screwdriver, remove the eight flathead screws holding the
patch panel to the mounting brackets.
4 With a Phillips screwdriver, remove the six flathead screws holding the
mounting brackets to the chassis.
5 Store the mounting brackets and screws as required.