Play/Pause; Selecting A Track Via The Track-Buttons; Synchronisation Of The Playback-Speed; Programming - Omnitronic CDP-180 Manual Del Usuario

By using the Time-button, the time-indication can be switched from track remain time (Remain) to track
playback time (Elapsed).
Above the time-indication, 10 bars are displayed showing the remaining track-time visually. The shorter the
track remain time becomes, the less bars are displayed. 15 seconds before the track-end, the bars in the
display start flashing.
The indication "CONTINU" means that the CD-player is in normal playback mode. By pressing the Single-
button, the CD-player is put into Single-mode and the display shows "SINGLE".
The indication "0.0" means that the playback-speed has not been changed. If you adjust the playback-speed
via the Pitchfader (Pitch-button has to be pressed), the respective percentage is indicated in the display.

6.4 Play/Pause

In the Pause-mode the the time-indication in the display stands still and the Play/Pause-LED flashes. The
playback of the first track can be started by pressing the Play/Pause button. In the Playback-mode, the time-
indication in the display is running and the Play/Pause-LED shines permanently.
If you wish to interrupt the playback, press the Play/Pause-button and the laser stops at the position where
you stopped.

6.5. Selecting a track via the Track-buttons

You can select the desired track via the Track-buttons.
In order to play a track from the beginning, press the Track-buttons until the desired track number is
displayed. If you hold the respective Track-button, the CD-player will run through the track numbers until you
let the button loose.
«-button:
If you press the «-button once, playback starts at the beginning of the previous track. If a track is already
played back, you can start the current track from the beginning.
+10-button:
By pressing the +10-button, the CD-player jumps 10-stepwise from track number to track number (e. g. 06,
16, 26, 06).
»-button:
If you press the »-button once, the playback starts at the beginning of the next track, if you press it twice the
following track, etc.
Please note that the CD-player calls the track up in the mode you pressed the Track-button. If the CD-player
is in the Play-mode at track 1 for example and you press the »-button, the player jumps to track 2 and
immediately starts playback.

6.6 Synchronisation of the playback-speed

You can synchronise the CD player and another signal-source while cueing with the headphones via the
mixer.
Possibility 1:
Put the CD-player into playback-mode and cue with the headphones. Synchronise the playback-speed via
the Pitchfader ot the CD-player (Pitch-button has to be pressed).
Possibility 2:
If the two signal-sources only differ in the bass-beat, you can synchronise via the Pitch Bend-buttons.
Put the CD-player into playback-mode and cue with the headphones. Synchronise the bass-beat via the left
or right Pitch Bend-button.

6.7 Programming

Create a program:
Press the Program-button. The display shows "- -" for indicating the track-number and "01" for indicating the
program-number.
Press one of the Track-buttons until the display will show the desired track number for the program-number
1. Press the Program-button in order to save the track.
Press one of the Track-buttons again in order to choose a track for the next program-number.
21/43 10602248_V_1_0.DOC