IKRA IHS 650 Instrucciones De Manejo página 20

Intended use
This hedge trimmer is only intended to be used to trim shrubs, bushes, ornamental plants and hedges. It is designed to
cut branches with a diameter of no more than 22 mm (IHS 650). The hedge trimmer is not intended for commercial use.
The user of the hedge trimmer must make sure that the protective equipment specified in the operating instructions and
by the warning label on the trimmer is attached whenever the trimmer is in use. The hedge trimmer must be checked
for electrical or mechanical damage before it is used or while it is being used.
Stop working and contact a specialist workshop if you find any damage.
Improper use
Any use not identified in the chapter „Intended use" is an improper use.
The user of the hedge trimmer is solely liable for any property damage or personal injury arising from improper use of
the hedge trimmer.
The manufacturer's obligation to honour the warranty is voided if the hedge trimmer is used with non-original parts
Residual dangers
Residual risks always remain even if the hedge trimmer is used properly. The hedge trimmer's design can entail the
following hazards:
• Contact can be made with the unprotected blade (resulting in cutting injuries)
• Reaching into or grabbing the hedge trimmer while it is in operation (resulting in cutting injuries)
• Unanticipated, sudden movement of the plant material being cut (resulting in cutting injuries)
• Ejection or catapulting of damaged cutting teeth
• Ejection or catapulting of the plant material being cut
• Hearing damage if the specified hearing protection is not worn
• Inhalation of cut materials
Electric Hedge Trimmer
Technical data
Operating Voltage
Nominal Frequency
Nominal Consumption
No-load Speed n
0
Cutting length
Cutting capacity
Weight (without flex)
Noise Pressure Level L
pA
Vibration according to EN 60745
Class of protection: II / DIN EN 60745/VDE 0740
Emissions
- The specified vibration emission value was measured by a standardized test methods and can compare with other
power tools are used.
- The specified vibration emission value can also be necessary for the assessment of work breaks are used.
- The specified vibration emission value can vary during the actual use of the electric tool by specifying the value,
depending on the way how to use the power tool.
- Note: You create the privilege against vascular pulsations of the hands in time breaks.
The noise pressure level at the place of work can exceed 80 dB(A). In such cases the operator will require noise
protection (e.g. wearing of ear protectors).
Attention: Noise protection! Please observe the local regulations when operating your device.
Interference suppressed in accordance with EN 55014, EN 61000-3-2, EN 61000-3-3.
We reserve the right to make changes to the technical specifications.
The devices are manufactured in accordance with the provisions of EN 60745-1and EN 60745-2-15 and fully comply with
the provisions of the German Product Safety Act.
GB | Operating Instructions
according to 2000/14/EG
IHS 650
V~ 230-240
Hz 50
W 650
-1
min 1500
mm 550
mm 22
kg 3,2
dB (A) 90,5 K 2,5 dB (A)
2
m/s 4,4 K 1,5 m/s
GB-2
Translation of the original Operating Instructions
2