Remote Control - dyso Pure Hot + Cool Manual De Instrucciones

Power
Each time the heating mode is selected, it conducts a
short calibration cycle. Airflow will be automatically
controlled during this cycle. Once the calibration cycle is
complete, it will revert to the selected airflow speed.
On first use, the appliance will default to a temperature
3°C higher than the detected room temperature.
Thereafter, the appliance will remember the last target
temperature set.
Select the desired room temperature. Pressing the
large red button on the remote control increases the
target temperature by 1°C; the smaller red button on
the remote control decreases it by 1°C. The appliance
will not operate in heater mode unless the target
temperature is above the room temperature.

Remote control

Standby
ON/OFF
Airflow speed
control
Sleep timer
Focused
mode
Remote control docks magnetically.
Attach the remote control to the top of the machine
with the buttons facing down.
44
Heating and cooling modes
Cooling
mode
Thermostat
control
Oscillation
ON/OFF
Diffused
mode
To operate, point the
remote control toward
the front of the base.
Press and hold the power button to run
through the target temperatures.
Press the red thermostat control button until the digital display shows
the target room temperature. The power button light will change from
blue to red to indicate that you have entered heating mode. The red
circle will disappear when the target room temperature is reached.
Once the target room temperature has been reached, the appliance
will stop heating the air. If the room temperature falls below the target
room temperature, the appliance will start to heat again.
Press the blue cooling mode button to enter cooling mode. The
power button light will change from red to blue to indicate that you
have entered cooling mode. To adjust the airflow speed use the
airflow control button.