Features; Assembly; Operation - Craftsman 315.CH2021 Manual Del Operador

ENERGY STAR QUALIFIED
This battery charger meets the Energy Star energy-
efficiency guidelines set by the U.S. Environmental
Protection Agency and the U.S. Department of Energy.
Battery chargers meeting this standard use an average of
35% less energy than conventional battery chargers.
WARNING:
Do not use this product if it is not
completely assembled or if any parts appear to be
missing or damaged. Use of a product that is not
properly and completely assembled could result in
serious personal injury.
 If any parts are damaged or missing, please call
1-800-932-3188 for assistance.
WARNING:
Do not allow familiarity with products
to make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
WARNING:
Always wear eye protection with side
shields marked to comply with ANSI Z87.1. Failure to
do so could result in objects being thrown into your
eyes resulting in possible serious injury.
APPLICATIONS
You may use this product for the following purpose:
 Charging compatible Craftsman 19.2 volt battery
packs.
CAUTION: I
f at any point during the charging
process none of the LEDs are lit, remove the
battery pack from the charger to avoid damaging
the product. DO NOT insert another battery. Return
the charger and battery to your nearest authorized
service center for service or replacement.
NOTICE:
Charge in a well ventilated area. Do not
block charger vents. Keep them clear to allow proper
ventilation.
CHARGING
See Figure 2, page i.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them before first use. If the charger does not charge your

FEATURES

KEY HOLE HANGER
See Figure 1, page i.
The charger has a key hole hanging feature for conve-
nient, space saving storage. Screws should be installed
so that the center distance is 4-1/2 in.

ASSEMBLY

WARNING:
or create accessories not recommended for use with
this product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.

OPERATION

battery pack under normal circumstances, return both the
battery pack and charger to your nearest repair center for
electrical check.
Charge time is approximately 30 minutes, and is
dependent upon the type of battery pack.
 Make sure the power supply is normal household
voltage, 120 volts, AC only, 60 Hz.
 Connect the charger to a power supply.
 Attach the battery pack to the charger by aligning the
raised ribs on the battery pack with the grooves in the
charger, then slide the battery pack onto the charger.
 Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
 Do not place the charger in an area of extreme heat or
cold. It will work best at normal room temperature.
 The battery pack may become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
 After charging is complete, the green LEDs will remain
on while the charger is in Maintenance Mode.
 After completing Maintenance Mode, the green LEDs
will begin fading on/off continuously. This indicates the
battery is fully charged and the charger is in Energy
Save Mode.
 Charger will periodically wake from Energy Save Mode to
ensure the battery pack remains in a fully charged state.
 To remove the battery pack from the charger, depress
latches and pull up on the battery pack.
5 — English
Do not attempt to modify this product