General Requirements; Important Information On Welding Parameters; Care And Maintenance; Machine And Tool Care - Rothenberger ROWELD P 110 Instrucciones De Uso

 Store basic machine and tools into transport case.
Let the heating element cool or stow it in such a way that no adjacent materi-
als can be ignited!
3.3

General requirements

As weather and ambient conditions can seriously effect welding procedures and joints, it is es-
sential to duly observe national welding guidelines and ordinances, e. g. DVS Guideline 2207,
Sections 1, 11 and 15.
Welding requires continuous and due supervision and monitoring!
3.4

Important information on welding parameters

For welding parameters such as temperature, pressure and time, consult your national welding
guidelines and ordinances, e. g. DVS Guideline 2207, Sections 1, 11 and 15.
Ordering: DVS Media GmbH, Aachener Str. 172, 40223 Düsseldorf
Postfach 10 19 65, 40010 Düsseldorf, Tel.: +49 (0) 211 / 15 91 – 0
Email: media@dvs-hg.de internet: www.dvs-media.info
In the event of doubt, consult the pipe manufacturer for material-specific welding parameters.
The welding parameters specified in the welding tables are strictly reference values. ROTHEN-
BERGER cannot assume any liability for their accuracy or completeness!
4

Care and maintenance

To ensure that the welding machine functions properly, observe the following maintenance rec-
ommendations:

The guide rails must be kept free of dirt. When their surface is damaged, the guide rails
must be exchanged.

The heating element must be operated only with the voltage stated on the type plate.

To achieve perfect welding results, it is essential to keep the heating plate clean. If the sur-
face is damaged or shows signs of erosion, the surface must be recoated or replaced. Mate-
rial residues on the heating plate surface reduces the non-sticking properties of the coating.
Remove all residues with non-linting paper and alcohol (heating plate must be cool!).

The trimmer is equipped with two double-sided ground knives. When cutting capacity starts
decreasing, the knives can be turned over or replaced by new ones.

It must always be ensured that the pipe or workpiece ends to be machined, especially the
face surfaces, are free of soiling because otherwise the service life of the knives will be
shortened.
It is recommendable to have repairs done only by a service workshop or by
the manufacturer!
4.1

Machine and tool care

(Follow the maintenance instructions in item 4!)
Sharp and clean tools produce better work results and are safer.
Replace blunt, broken or lost parts immediately. Check whether the accessories are securely
connected to the machine.
Use only original spare parts from the manufacturer for maintenance work. Repairs must be car-
ried out only by professionally qualified personnel.
Disconnect the machine from the mains when it is not in use, prior to care and maintenance
work and before changing accessory parts.
Prior to reconnection to the mains, it must be ensured that the machine and the accessory tools
are switched off.
When extension cables are used, they must be checked for their safety and operativeness. Only
cables approved for outdoor use must be used.
Tools and machines whose housing or handles, especially those made of plastic, are cracked or
warped must not be used.
ENGLISH 15