Charging The Battery - Invacare Aquatec Orca Manual Del Usuario

Set up and installation
4. Hold the backrest at the head end with one hand and fold it for-
wards to the end position (A).
5. Pull the backrest up off the seat and out of the bathtub (B).
6. Fold the side flaps of the seat inwards (C).
!
IMPORTANT
▸ Release both rear suction cups simultaneously.
A
7. Release the rear suction cup (A) by pulling up on its tab (B).
8. Lift the rear of the seat further. This releases the front suction cups.
!
IMPORTANT
▸ If the height adapters have been installed (optional), you
also have to pull the tabs of the front suction cups to
release them.
B
9. Lift the seat out of the bathtub.
10. Carefully store all components of the bath lift.

4.4 Charging the battery

The bath lift cannot be used when the battery is charging.
CAUTION Risk of electric shock!

▸ Only recharge the battery in dry rooms and never in the
bathroom.
!
IMPORTANT
▸ Only use the charger supplied (Aquatec®Orca/Orca F/Orca
XL) to charge the battery in the hand control.
▸ Only connect the charger to the mains when the hand
control is connected to the charger.
▸ Make sure that the voltage specifications shown on the
charger correspond to those of the mains supply.
A
F
E
1. Insert the jack plug (F) of the charger (C) into the jack socket (E)
on the spiral cable (D) of the hand control (A) until it engages.
2. Insert the mains plug (B) of the charger into a power socket.
The red indicator lamp (G) on the hand control extinguishes when the
battery is completely charged. It is not possible to „overcharge" the
battery.
3. Disconnect the charger from the power socket.
4. Pull the jack plug of the charger out of the jack socket of the hand
control.
Bathlift Orca / Orca F / Orca XL
B
G
C
D
9