Assembly; Loop Handle Installation; Attaching And Detaching For The Power Unit - Maruyama M27QC Manual Del Propietário

Assembly

Loop Handle Installation

Screw (4)
Nut (4)
The loop handle kit contains a package of four screws
and nuts, a rubber sleeve and the bottom clamp for the
loop handle.
1. Slip the rubber sleeve around the shaft approxi-
mately 11 inches (28 cm) from the end of the stop
switch/throttle trigger assembly for an initial han-
dle position.
2. Rotate the rubber sleeve so the split is to one side.
3. Place the loop handle and the bottom clamp over
the rubber sleeve.
4. Install the four screws and nuts. Leave the screws
finger-tight.
5. Reposition the loop handle up or down the drive-
shaft to the most comfortable position, but no
closer than 9 inches (22.8 cm) from the end of the
stop switch.
6. Tighten the screws and nuts.
Loop Handle
Bottom Clamp
— US-13 —
Attaching and Detaching for the Power
Unit and the Shaft Assembly
Attaching
1 First, loosen the clamping knob before attaching
the shaft assembly to the shaft coupler.
Note : Do not over loosen the clamping knob or it
may fall out.
2 Insert the shaft assembly to the shaft coupler with
the positioning hole faced up as shown. Connect
the both drive shafts completely in the matching
position by moving the shaft assembly to forward
and backward and left turn and right turn. When
the shaft assembly is positioned correctly, spring
tensioned positioning lever will be returned to the
initial position.
3 Tighten the clamping knob firmly.
Shaft Coupler
Clamping Knob
Loosen
Incorrect Assembled
Positioning lever is
lowered state
Correct Assembled
Positioning lever is
raised state
Positioning Lever
Positioning Hole
Shaft Assembly
Tighten
Insert
Positioning
Lever