Vacuum Package In A Canister - CASO DESIGN TouchVAC Manual Del Usuario

► Do not overstuff the bag; leave enough empty length in the open end of the bag (at least
a few inches) so that the bag can be properly placed in the vacuum chamber.
► Do not wet the open end of the bag. Wet bags may not seal properly.
► Clean and straighten the open end of the bag before sealing. Foreign matter or creases
on the bag may result in a faulty seal.
► Press the bag to expel excess air before vacuuming it. Too much air inside the bag may
result in a poor vacuum.
► If the food you're sealing has sharp edges (such as bones or shells) pack the edges
with kitchen paper to avoid tearing the bag
► We suggest you allow one minute of time in between sealing sessions to allow the
sealer to cool.
► When vacuum sealing liquid-based foods (such as soups or stew) freeze them first in a
baking pan or tempered dish before bagging and vacuum sealing them.
► Blanch vegetables by cooking them briefly in boiling water. Allow them to cool then
vacuum seal them in convenient portions.
► When vacuum sealing unfrozen food, allow at least two additional inches of bag length
for expansion while freezing. Place unfrozen meat or fish on a paper towel and vacuum
seal with the paper towel in the bag to absorb any extra moisture.
► Before storing foods such as tortillas, crepes or bread, use wax or parchment paper
between them to stack the pieces. This will make it easier to remove an individual piece,
reseal the rest and immediately replace them in the freezer.

16.3 Vacuum package in a Canister

Wipe canister cover, canister base and ensure they are clean and dry.
Put the items into the canister and do not fill up too full so that the cover can be in good
contact with the canister bowl rim. Close the cover.
Insert one end of the hose into the hose port and another end of the hose into the center
hole of the canister cover.
Check the LED status of "vacuumstrengh" and make sure if it is in "normal" setting.
Close the lid.
Press the "Canister" button to start vacuuming. To ensure there is no air leaking between
the cover and the canister, use your hand to push down the cover at the beginning of the
vacuuming work. The machine will stop automatically when enough vacuum pressure is
achieved.
Take out the hose tube from the canister or bowl immediately first after the job is
completed.
PLEASE NOTE
38