Troubleshooting - Teac SR-L280i Manual Del Usuario

If you have problems with your system, look through this
chart and see if you can solve the problem yourself before
calling your dealer or TEAC service center.
General
No power
Check the connection to the AC power supply. Check
and make sure the AC source is not a switched outlet
and that, if it is, the switch is turned on. Make sure
there is power to the AC outlet by plugging another
item such as a lamp or fan into the outlet.
No sound from speakers.
Select the source by pressing the FUNCTION button.
Adjust the volume.
If the MUTING indicator blinks on the display, press the
MUTING button.
The sound is noisy.
The unit is too close to a TV or similar appliances.
Install the unit apart from them, or turn them off.
Remote control unit does not work.
If the battery is exhausted, replace it with a new one
(see page 14).
Use remote control unit within the range (5 m) and
point at the remote sensor on the front panel.
Clear obstacles between the remote control unit and
the main unit.
If a strong light is near the unit, turn it off.
CD Player
Cannot play.
Load a disc with the label side up.
If the disc is dirty, clean the surface of the disc.
A blank disc has been loaded. Load a prerecorded
disc.
Depending on the disc, etc. it may not be possible to
play back CD-R/RW discs. Try again with another disc.
You cannot play back unfinalized CD-R/RW discs.
Finalize such a disc in a CD recorder and try again.
Sound skips.
Place the unit on a stable place to avoid vibration and
shock.
Do not use scratched, damaged or warped discs.

Troubleshooting

iPod Player
Cannot insert the iPod.
Check the dock adapter (see page 13).
Remove dust or obstacles from the Dock connector of
this unit and the iPod, and insert the iPod again.
Will not play.
Remove the iPod from the dock, wait a few seconds,
and insert it again.
Software update may solve the problem. Visit the
Apple website and download the latest iPod Software
(see page 13).
Cannot operate the iPod.
Set off the HOLD switch of the iPod.
Tuner
Cannot listen to any station, or signal is too weak.
Tune in the station properly.
Rotate the FM or the AM antenna until you get stations
clearly.
If normal operation cannot be recovered, unplug the
power cord from the outlet and plug it again.
35