Scope Of Delivery; Unpacking Of The Appliance; Explanation Of The Control Panel; Instructions - Profi Cook PC-TKS 1056 Instrucciones De Servicio

Scope of delivery

1 Base station
1 Kettle
1 Tee-/ Coffee maker
1 Filter

Unpacking of the appliance

1. Remove the appliance from its packaging.
2. Remove all the packaging material such as
foils, filler material, cable holders and cardboard
packaging.
3. Check the scope of delivery for completeness.
4. In the event that the packaging content should
be incomplete or if damages should be notice-
able, do not operate the appliance. Return it to
the dealer immediately.

NOTE:
There may still be dust or production residue on
the device. We recommend that you clean the
appliance as described under "Cleaning".

Explanation of the control panel

1 Reducing the warm-keeping temperature ( )
2 Increasing the warm-keeping temperature ( )
3 Temperature display
4 Pilot lamps (TEA / COFFEE)
5 Select the warm-keeping temperature preset by
the factory for coffee or tea (MOD)
6 Switching on/off the hotplate ( )

Instructions

Location
Put the base on a flat surface.
Preparation
Water kettle: Before using for the first time,
boil fresh water at least three
times in the appliance. Use
only water without any addi-
tives or ingredients.
Tea/coffee maker: Clean the tea/coffee maker
and filter as usual in soapy
water. Rinse with clear water
afterwards. Dry the tea/cof-
fee maker and filter with a
cloth.
Mains Lead
Completely unwind the required power cord from
the bottom part of the base. Pay attention to the
guide of the power cord.
Electrical connection
Check whether the electrical voltage that you intend
to use is the same as that of the machine. Details
are to be found on the label on the base.
Connected Wattage
The total power consumption of this device can be
up to 2500 W. With this connected load a separate
supply line protected by a 16 A household circuit
breaker is recommended.
CAUTION: Overload!
• If you use extension leads, these should have
a cable cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this device
is too powerful.

Operating the water kettle


NOTE:
Always use fresh, cold water.
1. Press the button in the lid to open the kettle.
The opener will spring open. Remove the lid.
2. Then fill in the water. Please only fill up to the
maximum (MAX) mark. You can read the filling
level on the water level indicator of the kettle.
3. Place the lid onto the appliance. Press the but-
ton in the lid to close the lid. The button must
click in audibly.
4. Put the water kettle onto the connecting joint of
the base.
47