Replaying A Message Sequence; Time-Controlled Replay; Creating A Schedule - Monacor PA-1120DMT Instrucciones Instalación Y Funcionamiento

5) Press the button ENTER . If no program has
been created yet, the display will show:
PGM Edit
P01 ---
6) Use the button UP or DN to select the storage
location ( –
M1 M6
age]) for the first program step
7) Press the button START/ STOP (14) . Use the but-
ton UP or DN to select the storage location for
the second program step
8) Proceed in the same way to store all messages
to be replayed in the desired order . Finally,
press the button START/ STOP and then the but-
ton ENTER or wait for approx . 30 seconds until
programming will be automatically finished .
Pressing the button ENTER will delete the
program step most recently shown, delete the
subsequent program steps and exit program-
ming . Then the replay mode will be selected
again ( ☞ chapter 6 .4 .2) .
Note: When program step 20 has been entered, wait
for approx . 30 seconds to exit programming; pressing
the button ENTER will delete all program steps .

6.4.2 Replaying a message sequence

1) Press the button MENU (10) . The display will
show:
Mode Set
Time
2) Press the button UP (12) or DN (11) repeatedly
until appears on the lower display
RECALL
line .
3) Press the button ENTER (6) . The display will
now show:
RECALL
PGM Play
4) Press the button ENTER . The display will show,
for example:
PGM Play
P01 M6
5) Press the button START/ STOP (14) . The replay
will start and the display will now show:
PGM Play
P01 ....
The programmed messages will be replayed
one after the other and the indication of the
program step replayed will change accordingly:
, , , ...
P01 P02 P03
or – ["voice" stor-
V01 V20
.
P01
.
P02
6) To stop the replay, press the button START/ STOP
again .
7) When the replay is started via the button RE-
PEAT/ STOP (13), the replay will stop after each
message . To start the subsequent message of
the program, press the button again .
Pressing the button while a message is
being replayed will stop the message; to re-
play the next message, press the button again .

6.5 Time-controlled replay

The stored messages may automatically and
regularly be replayed at specific times; for each
weekday, up to 20 different times for replay can
be defined . The schedule of a weekday can be
copied to other weekdays, if required .

6.5.1 Creating a schedule

1) Press the button MENU (10) . The display will
show:
Mode Set
Time
2) Press the button UP (12) so that
appear on the lower display line .
3) Press the button ENTER (6) . The display will
now show:
Choose
Week Set
4) Press the button ENTER . The display will show:
Program
Mon
5) Press the button UP or DN (11) to set the week-
day desired ( chapter 5 .3) .
☞
6) Press the button ENTER . The display will show,
for example:
CH:01 01
16:10 21
(program location 1, replay once,
start time 16:10 h, message M1)
Note: The numbers 01 – 20 indicate the messages
Voice01 – 20; the numbers 21 – 26 indicate the mes-
sages M1 – M6 .
7) Use the button UP or DN to search for a free
program location
and then press the button ENTER . The display
will show:
Program
Change
Press the button ENTER .
Program
CH:XX --/--:-- --
will
21