How To Operate The Machine; How To Start/Stop The Machine; How To Control The Machine - Clarke MP-1800 Instrucciones De Uso

EN

HOW TO OPERATE THE MACHINE

How To Start/Stop The Machine

WARNING!
Never start a polisher when the handle is in the vertical position.
The following steps apply to MP-1800:
The switch to start and stop the machine is activated by the interlock switch (1) and the levers (2) under the handle grips. See fi gure
5.
To start the machine, follow this procedure:
1. Lower the handle
2. Lock the handle in the best position for operation.
NOTE: Make sure you hold the handle with both hands.
3. Push the interlock switch (1), and apply pressure to the levers (2). See fi gure 5.

How To Control The Machine

NOTE: Make sure you hold the handle with both hands.
The side to side movement of the machine is controlled by raising the handle and pressing down on the handle. To move the machine
to the left, press down on the handle slightly. To move the machine to the right, raise the handle slightly.
MAINTENANCE
WARNING!
Maintenance must be done by authorized personnel only.
Maintenance Instructions
Return the machine to a Clarke Authorized Service Location every 12 months for maintenance inspections.
-6 - FORM NO. 70193B
1
2
Figure 5
Clarke
2
® Operator's Manual - MP-1800 Marble Polisher