Installation And Connection - Tristar MW-2897 Manual De Usuario

4
2
3
Turntable Installation
• Never place the glass tray upside down. The glass tray should never be
restricted.
• Both glass tray and turntable ring assembly must always be used
during cooking.
• All food and containers of food are always placed on the glass tray for
cooking.
• If glass tray or turntable ring assembly cracks or breaks, contact your
nearest authorized service center.

INSTALLATION AND CONNECTION

• Remove all packing material and accessories. Examine the oven for any
damage such as dents or a broken door. Do not install if the oven is damaged.
• Remove any protective film, found on the microwave oven cabinet surface.
• Do not remove the light brown Mica cover that is attached to the oven
cavity to protect the magnetron.
• Select a level surface that provide enough open space for the intake
and/or outlet vents.
8
• The rear surface of appliance shall be placed against a wall. A minimum
clearance of 7.5cm is required between the oven and any adjacent
walls. One side must be open. Leave a minimum clearance of 30cm
above the oven. Do not remove the feet from the bottom of the oven.
• Blocking the intake and/or outlet openings can damage the oven.
• Place the oven as far away from radios and TV as possible. Operation of
microwave oven may cause interference to your radio or TV reception.
• Plug your oven into a standard household outlet. Be sure the voltage and the
frequency is the same as the voltage and the frequency on the rating label.
• Do not install the oven over a stove or other heat-producing appliance.
If installed near or over a heat source, the oven could be damaged and
the warranty would be void.
The accessible surface may be hot during operation.
OPERATION INSTRUCTION
This microwave oven uses modern electronic control to adjust cooking
parameters to meet your needs better for cooking.
Clock Setting
When the microwave oven is electrified, the oven will display "0:00", buzzer
Microwave-grill
EN
7