Troubleshooting - Haier HAS1460TVE Manual De Usuario

TROUBLESHOOTING

TROUBLESHOOTING
The following circumstances do not constitute problems. Do not contact the Service Center until the problem has been confi rmed.
PROBLEM CAUSES
Washing machine fails to ¬ Poor connection to the power supply.
operate. ¬ Power failure.
¬ The washer door is not properly closed.
¬ Machine has not been switched on.
Washing machine cannot be ¬ The "Start/Pause" button is not pressed.
fi lled with water. ¬ Water tap is not turned on.
¬ Water pressure is less than 0,03 MPa.
¬ The inlet hose is kinked.
¬ Water supply failure.
¬ The program knob is not properly set.
¬ The washer door is not properly closed.
¬ The inlet hose fi lter is blocked.
Machine is draining while ¬ The height of the drain hose is below 80 cm.
being fi lled. ¬ The drain hose is in water.
Drainage failure. ¬ Drain hose is blocked.
¬ Drain hose end is higher than 100 cm above
the fl oor level.
¬ The fi lter is blocked.
Strong vibration while ¬ Not all transportation bolts have been removed.
spinning. ¬ Washing machine is located on an uneven
surface or is not level.
¬ Machine load is over 6 kg.
Operation stops before ¬ Water or electricity failure.
completing wash cycle.
Operation stops for a period
of time. ¬ Washing machine gives an error message.
Excessive foam in the ¬ The detergent is not a low-foaming type or for
drum, which is spilled to the manual wash.
distribution drawer. ¬ Excessive use of detergent.
Automatic adjustment of the ¬ The washing program duration will be adjusted
washing time. according to the initial water temperature.
Spinning fails ¬ Unbalance of the laundry
MAINTENANCE
SOLUTIONS
_ Check connection to the power supply.
_ Check the power supply.
_ Close the washer door properly.
_ Make sure the machine is switched on.
_ press the "Start/Pause" button.
_ Turn on the water tap.
_ Check water pressure.
_ Check the inlet hose.
_ Ensure the water supply.
_ Set the program knob properly.
_ Close the washer door properly.
_ Unblock the inlet hose fi lter.
_ Install drain hose within 80-100 cm of height.
_ Make sure the drain hose is not in water.
_ Unblock the drain hose.
_ Make sure the drain hose end is lower than
100 cm above fl oor level.
_ Unblock the fi lter.
_ Remove all transportation bolts.
_ Make sure the washing machine is on
an even surface and levelled.
_ Reduce amount of laundry in the drum.
_ Check the power supply.
_ Check display codes.
_ Check if your detergent is appropriate.
_ Reduce amount of detergent in the distribution
drawer.
_ This is normal and doesn't affect the
functionality.
_ Add clothes or run a spinning program again.
19