Names And Functions Of Parts (Display) - Esoteric Grandioso D1 Manual Del Usuario

Names and functions of parts (display)

a b
L c h DSD DIRECT
E S L I N K
e
a
Channel
This shows the channel played back by this unit (page 15).
No indicator:
No channel has been set for this unit. Use this setting only with
mono output from a source device.
Lch:
This unit is set to the front left channel. By connecting the L-R
connectors of this unit and the D1 set to Rch, they can share var-
ious settings and during stereo output the right channel audio
signal from the audio source device can be sent to the Rch D1.
Rch:
This unit is set to the front right channel. By connecting the L-R
connectors of this unit and the D1 set to Lch, they can share vari-
ous settings and during stereo output the right channel audio
signal from the audio source device can be sent to this unit for
playback.
b
Upconversion setting
No indicator:
The upconversion function is not in use.
UPCONV 2Fs:
The upconverter circuit will upconvert the signal to 64, 88.2 or
96 kHz before digital to analog conversion.
UPCONV 4Fs:
The upconverter circuit will upconvert the signal to 128, 176.4 or
192 kHz before digital to analog conversion.
UPCONV 8Fs:
The upconverter circuit will upconvert the signal to 256, 352.8 or
384 kHz before digital to analog conversion.
UPCONV DSD:
The upconverter circuit will convert the PCM signal to a DSD sig-
nal before digital to analog conversion.
DSD DIRECT:
If DSD_F (DSD filter) is set to OFF, this appears when a DSD signal
is input.
o Even if the upconverter is set, the upconverter might not be
usable depending on the input source sampling frequency
conditions.
o You can make settings as you like for each input.
o When ES-LINK input is selected, this can only be set to OFF or
DSD.
c d
MCK IN 10MHz
3 5 2
f
c
Clock mode
No indicator:
CLK is set to OFF.
CLK OUT:
Shown when CLK is set to OUT.
The frequency display area shows the output clock frequency.
CLK IN:
Shown when CLK is set to IN.
The frequency display area shows the input clock frequency.
MCK IN:
Shown when CLK is set to MCK IN or MCK10M.
The frequency display area shows the input clock frequency.
INTERNAL:
This is shown when unsynchronized signals are received during
USB input.
The frequency display area shows the master clock frequency
being used.
d
Clock frequency
e
Input
f
Sampling frequency
11 11