Dimmer Setting; Analog Output Setting; Automatic Display Darkening Setting; Automatic Power Saving Setting - Esoteric Grandioso D1 Manual Del Usuario

Setting mode (continued)

Dimmer setting

DIMMER>***
You can adjust the brightness of this unit's display and indicators.
By default, the setting is 3.
3 (normal brightness)
2
1
0
o The dimmer of this unit can be adjusted using the DIMMER button
of a remote control included with a P1 or other Esoteric product.
o Even when set to any value other than 3 (normal brightness), nor-
mal brightness will be used when displaying error messages and
setting menus.

Analog output setting

AOUT>***
Use this to select the analog output connector to be used.
By default, the setting is XLR2.
RCA
An analog audio signal is output from the RCA connector.
XLR2
An analog audio signal is output from the XLR connector with pin 2
HOT.
XLR3
An analog audio signal is output from the XLR connector with pin 3
HOT.
16 16

Automatic display darkening setting

DPaOFF>***
You can set the display to darken automatically after a set amount of
time has elapsed.
By default, the setting is ON.
ON
The display will automatically darken after 30 minutes elapse without
any operation or change in the information shown.
OFF
The display will not automatically darken.
o We recommend setting this to "ON" because brightness irregulari-
ties might occur if the same information is shown without change
on the display for a long time.

Automatic power saving setting

APS>***
The unit will turn off automatically if the set amount of time passes
without an input signal being locked.
By default, the setting is 30m.
o The input sources that are not selected have no effect on auto-
matic power saving.
30m
30 minutes
60m
60 minutes
90m
90 minutes
120m
120 minutes
OFF
The automatic power saving function is disabled.