Technical Specifications - Elettro LEM61211 Instrucciones De Uso

BATTERY CHARGER ITEM 620 – LEM61211
BEFORE USING YOUR BATTERY CHARGER READ WARNINGS AND INSTRUCTIONS CAREFULLY
This charger is designed to charge various types of 6 and 12 Volt lead batteries (for example WET,
GEL, AGM etc.), widely used in cars, motorcycles and other kind of vehicles, with capacity range from
2,2 Ah to 40 Ah at 12 Volt or 2,2 Ah to 14Ah at 6 Volt. Do not charge different types of batteries or faulty
batteries.
Protection rating IP65 against external agents.
Not suitable to supply power to a low voltage electrical system.
Do not use for any other purpose.

1. TECHNICAL SPECIFICATIONS

Input power supply
Absorbed power
Input current
Cut off voltage
Charging current
Back Drain Current
Ripple
Type of battery
Protection class
Noise
Operating temperature
Internal fuse
2. LUMINOUS SIGNALLING
Signal
LED ON (green)
LED ON (orange)
LED 6V ON (red)
LED 12V ON (red)
LED 25% blinking (red)
LED 25% ON;
LED 50% blinking (red)
LED 25%, 50% ON
Led 75% blinking (yellow)
LED 25%,50%,75% ON
LED 100% blinking (green)
LED 25%,50%,75%,100% ON
LED and LED
25%,50%,75%,100% blinking
3. HOW TO SELECT THE DIFFERENT MODES
You can select the desired mode by pressing the MODE button.
220-240V AC 50/60Hz
30W
0.35 A RMS. Max
14.4 +/-0.25V or 7.2 +/- 0.25V
1.1A +/- 10%
<5mA (No AC input)
150mV Max o.3 A
Lead 12V: 2.2Ah - 40Ah
Lead 6V: 2.2Ah - 14Ah
IP65
<50dB (tests carried out at 500mm)
0 - +40° C
1.0A/250V
Condition
Mode STANDBY
Reversed polarity
Mode 1
Mode 2
Charging
Charging
Charging
Charging
In maintenance
Error indicator
9
Remarks
Standby, battery charging or in case
of open circuit or short circuit
Reverse the polarity
Mode 6V (7.2V – 1.1A)
Mode 12V (14.4V – 1.1A)
Charging (below 25%)
Charging (below 50%)
Charging (below 75%)
Charging (below 100%)
Fully charged, in maintenance
Faulty battery