Tips For Troubleshooting - Abus TVAC15000B Manual Del Usuario

10. Tips for troubleshooting

No. Question
1 What does pairing the
monitor and camera mean
and how does this work?
2 What could be the reasons
why the monitor displays
"NO SIGNAL" instead of a
picture?
3 What could be the reasons
why the device does not
record?
4 What could be the reasons
why the device does not
record when there is
movement?
5 What should I do if, in night
mode, half of the image
shows nothing and remains
black?
6 Is a standby mode possible?
7 Can the sound for the
motion detection be
adjusted?
8 Can more than one monitor
be used at the same time?
Answer
Pairing creates the exclusive, encrypted wireless connection
between the monitor and camera.
To connect a camera to the monitor, proceed as follows:
1. Connect the power supply units to the cameras and the
monitor.
2. In the "Camera Setup -> Pairing" menu of the TFT monitor,
select a camera (1-4) and confirm the selection with OK.
The system counts down from 60 seconds.
3. During the 60 seconds, press the PAIRING button on the
camera cable until the green LINK LED on the front of the
camera starts flashing.
4. Once the connection is established, the LINK LED on the
camera is lit up continuously and the monitor switches to
live view.
Please note that connection can take up to 60 seconds.
If you do not have a picture signal, please check the following:
1. Is the camera connected to the power supply (does the
LED light up red)?
2. Are the camera and monitor paired with each other?
3. Is the camera within range of the monitor?
4. Is the signal between the camera and monitor disrupted?
If your device does not record, please check the following:
1. Have you inserted an SD card?
2. Is the SD card locked? (Lock/Unlock?)
3. Have you formatted the SD card? It must be formatted
before it is first used.
The "motion detection" function may be switched off. Please
go into the "Recorder Setup / Motion Detection / ON/OFF"
menu and set the function to "ON".
The camera has an integrated infrared swivel filter which
ensures the camera switches to night mode when it is dark. If
part of the image is black, it is possible that the swivel filter has
got stuck mechanically. Tapping the camera lightly can solve
this problem.
You can switch the device to an energy saving mode. If the
camera detects a movement during this time, the image is
automatically displayed.
Yes, in the menu item "Record Settings" you can turn off the
alarm tone. You will find this under "Alarm Period".
No, for technical reasons this is not possible because a
camera can only be paired directly with one monitor
(camera(s) and monitor form a pair).
22
English