Installation Using 723 Belt Clip; Parking Clip; Battery Replacement - 3M 725 Manual De Instrucciones

Section 5.
Installation Using 723 Belt
Clip (Optional)
An optional belt clip is available to
further enhance the portability feature
of the Model 725 Monitor. This
expands the use of the monitor when
operators need to be highly mobile as
in an electronic manufacturing
environment. Simply attach the belt
clip with female snap connector to the
male snap connector on the monitor
bottom cover. Slide the clip over your
belt in a convenient place, so that the
wrist strap ground cord will not
interfere with normal body
movements when attached to the
monitor. Attach the dual conductor
ground clip to a suitable ground
at the work location. During
mobility, attach the dual conductor
ground clip to the parking clip on
the Model 725 Monitor
(See Section 6).
Section 6.

Parking Clip

Fig.5
8
A parking clip is supplied with the
Model 725 Monitor allowing mobile
users to silence the ground clip
disconnect alarm. Attaching the dual
conductor ground clip to the parking
clip prevents unnecessary
disconnecting/connecting of the wrist
strap ground cord from the input jack
during mobility. An added benefit of
this feature is that it extends the life of
the dual conductor ground cord plug
and the monitor's input jack. The
parking clip is already attached to the
mounting tab of the Model 725
Monitor. If the Model 725 is to be
mounted under a work bench for
permanent use, remove the parking
clip from the Model 725 Monitor using
a small screwdriver.
Section 7.

Battery Replacement

Fig. 6
When only the red lamp illuminates on
the Model 725 Monitor, it is time to
change the battery. Unplug the wrist
strap ground cord from the 725
Monitor jack before proceeding.