Dip-Switch Setting - Cardin T624 Instrucciones De Uso

I GB
SAFETY DEVICE EXCLUSION DIP-SWITCHES
Use these dip-switches (part. 23 fig. A) to excluded inputs of unused safety devices.
A dip-switch set to ON (Excluded) is the same as bridging the Common (binding post 6) and any one of these 7 inputs.
Function n. OFF-ON
OFF
BSC
1
ON
OFF
BSA
2
ON
OFF
3
FT1
ON
OFF
4
FT2
ON
OFF
5
J1
ON
OFF
J2 6
ON
OFF
7
STP
ON

DIP-SWITCH SETTING

Select the desired options which will become active once one of the following conditions has been met:
- resetting the ECU (short circuit the RESET binding post 14 fig. A)
- switch the power to the ECU OFF and ON
- at the end of a complete closing cycle the new settings will be read.
Function n.
STEP-BY-STEP
INPUT
1
AND
RADIO
2
CHANNEL
MODE (CH1)
45
Mode
With a closing safety edge installed
Excludes the closing safety edge input.
EXCLUDED
Attention! Binding post 4 must remain disconnected.
With an opening safety edge installed
Excludes the opening safety edge input.
EXCLUDED
Attention! Binding post 5 must remain disconnected.
With installed photoelectric cells
Excludes the input for photocell 1. The same as bridging binding post 6 with the
EXCLUDED
common
With installed photoelectric cells
Excludes the input for photocell 2. The same as bridging binding post 7 with the
EXCLUDED
common
With a device installed
Excludes the input J1. The same as bridging binding post 8 with the common
EXCLUDED
With a device installed
EXCLUDED Excludes the input J2. The same as bridging binding post 9 with the common
With a STOP button installed
EXCLUDED Excludes the STOP input. The same as bridging binding post 13 with the common
Off - On Mode
OFF
OPEN - STOP -
CLOSE
OFF
ON
OPEN - CLOSE
OFF
OFF
ALWAYS OPENS
"CONDOMINIUM"
ON
OPENS-CLOSES
ON
with no reversal
ON
during opening
Descrption
During opening, upon pressing the P/P button the gate stops, pressing it
again the gate closes.
During closing, upon pressing the P/P button the gate stops, pressing it
again the gate opens.
During opening, upon pressing the P/P button the gate stops for a few
seconds and then closes.
During closing, upon pressing the P/P button the gate stops for a few
seconds and then opens.
During opening, pressing the P/Pbutton has no effect. During the pause,
pressing the P/Pbutton has no effect.
During closing, upon pressing the P/P button the gate stops for a few
seconds and then opens.
During opening, pressing the P/Pbutton has no effect. During the pause,
upon pressing the P/Pbutton the gate closes.
During closing, upon pressing the P/P button the gate stops for a few
seconds and then opens.
Descrption