Cardin T624 Instrucciones De Uso página 53

8
M1
9
M1
END PROG.
PROGRAMMING OF PEDESTRIAN OPENING (only for automations with one motor,
dip-switch 11 to OFF)
The partial opening command can be activated through the PED input (term. 12) or with the second channel of the OC2
receiver (dip-switch 7 OFF);the options are those set for the Step-by-Step with function dip-switches 1 and 2.
In 2 motor mode (dip-switch 11 ON),the pedestrian command fully opens just the gate leaf with M1
In 1 motor mode (dip-switch 11 OFF),the pedestrian command partly opens the gate leaf with M1.The time is set at approx. 1/3
of total opening movement; to change the time, proceed as follows.
2
PROG. P3 P/P
STOP
3
4
5
t
6
7
END PROG.
Once the desired pause time has elapsed, press button P/P and the motor will
begin to close.
At this point you may manually insert the DECELERATION start point using
P/P if DIP 9 is set to ON. The motor will stop for a second and then begin to
move again.
When the gate has completed the closing cycle the motor will stop, led LD1 will switch off and
the ECU will quit the programming procedure.
Checks: force, work times and stopping points. Decide whether or not to use deceleration
(recommended), DIP 9 ON to reduce the impact on the mechanical travel limits and to reduce
mechanical wear and tear.
If you modify the mechanical travel limits you must repeat the programming cycle.
Cut off the power supply to the control unit.
Release the motors and put the gate leaves in the "almost open" position.
Lock the motors and power the installation.
Press the PROG button (part 17, fig. E) and hold it down for about 3 seconds, until
LED LD1 (part 9, fig. E) remains constantly on.
The control unit is now in programming mode.
LD1
Press the PED button (connected to the input term. 12 or the memorized remote
PED
control). The gate closes and when the limit position is acknowledged, it opens
again automatically.
When the gate reaches the desired opening position, press the PED button again;
the control unit stores the time and closes the gate.
PED
When the closing movement is complete, the control unit exits automatically from
programming.
GB
52