Electrolux EFA 9673 Manual De Instrucciones página 23

Installing the structural support to Installing the structural support to
Installing the structural support to Installing the structural support to Installing the structural support to
the cooker hood the cooker hood
the cooker hood the cooker hood the cooker hood
• Fix the cooker hood to the structural
support using 16 screws (4 per
bracket).
Installing the structural support to Installing the structural support to Installing the structural support to
Installing the structural support to Installing the structural support to
the ceiling the ceiling
the ceiling the ceiling the ceiling
• Place the template on the ceiling
directly above the hob (the centre
and sides of the template should be
aligned with the centre and sides of
the hob).
Note: The side displaying the text Note: Note: Note: Note:
"FRONT" corresponds to the side
which will house the control panel
once installation is complete.
• Make the holes as indicated on the
template (6 holes for 6 screw
anchors) and partially tighten 4
screws into the screw anchors in the
corners (leave approximately 1 cm
between the head of the screw and
the ceiling).
• Prepare the electrical connection.
• Ducted version only: Ducted version only: Install an Ducted version only: Ducted version only:
Ducted version only:
exhaust tube long enough to reach
the outlet ring located above the
cooker hood.
The tube should be fitted to the
ceiling as an exhaust system to expel
fumes outside; the visible part should
be 180 mm shorter than the
structural support (please refer to
measurement E E E E E calculated
previously).
electrolux electrolux electrolux installation electrolux electrolux
FRONT
6 x Ø 10 + 4 x Ø 6x70
SX
FRONT
E (mm)-180
23 23 23 23 23
GB
DX