Guarantee; Parts Subject To Wear And Tear - Solo 128L Manual De Instrucciones

11. Guarantee

The manufacturer guarantees trouble-free quality
and will cover the cost of replacing parts which are
found to be faulty in material or workmanship
within the prescribed guarantee period after the
date of purchase. Please note that specific
guarantee conditions may vary from country to
country. If in doubt, ask your equipment vendor.
He is responsible for guarantee matters.
We hope you will understand that we cannot be
liable for damage resulting from the following
causes:
 Non-compliance with the operating
instructions.
 Neglecting essential maintenance and repair
work.
 Damage caused by incorrect carburettor
adjustment.
 Wear in normal use.
 Obvious overload by continuously exceeding
the maximum performance limit of the
product.
 Using non-authorised tools.
 Use of force, incorrect treatment, misuse and
accidents.
 Damage from excessive heat due to dirt build-
up around the cooling fan housing.
 Attempted adjustments and repairs by
unqualified persons.
 Use of unsuitable spare parts or third party
parts, if these are the cause of the defect.
 Use of unsuitable or stale fuel.
 Damage caused by using the product in the
hire or rental industry.
Normal cleaning, adjustments or maintenance
work fall outside the guarantee provisions.
A service centre authorised by the manufacturer
must carry out all guarantee work.
Guarantee; Parts subject to wear and tear

12. Parts subject to wear and tear

Various parts are subject to application-specific or
normal wear and must be replaced in good time,
when required. The following parts are subject to
normal wear and are not covered by the
manufacturer's guarantee:
 Air filter
 Fuel filter
 All rubber parts which come into contact with
fuel
 Clutch
 Spark plug
 Starter
 Cutting tools
ENGLISH 21