Honeywell C7189U Instrucciones De Instalación página 3

CAUTION
ELECTRICAL HAZARD.
Can cause electrical shock or equipment damage. Disconnect power before wiring.
1. Run the wire cable from the thermostat to the
remote sensor location.
2. Loosen screw terminals, insert wires into termi-
nal block (polarity does not matter), then
retighten screws.
3. Push excess wire back into the wall opening.
4. Plug the wall opening with non-flammable insu-
lation to prevent drafts from affecting the sensor
operation and replace the cover on the remote
sensor.
5. Connect the two wires to the thermostat's
remote
sensor terminals (polarity does not matter) and
replace the thermostat back onto the wallplate.
See Fig. 6.
Y2
W2
S1
S2
POWER SUPPLY. PROVIDE DISCONNECT MEANS AND
1
OVERLOAD PROTECTION AS REQUIRED.
IF MORE THAN ONE C7189 REMOTE SENSOR IS REQUIRED,
2
REFER TO FIGURE 7.
WIRES MUST HAVE A CABLE SEPARATE FROM THE
3
THERMOSTAT CABLE.
Fig. 6. Wiring a single C7189U Sensor.
OPERATION
Once a remote indoor temperature sensor is
connected to the thermostat, the thermostat's sensor
is no longer used. The thermostat's installer setup
should be modified to tell the thermostat that remote
indoor temperature sensor(s) have been used. The
Inside temperature reading on the thermostat's
display will be the remote sensor(s) temperature
location(s). See Fig. 8.
C7189
2
3
RC
R
W
Y
G
C
Fig. 5. Terminal block wiring.
1
R
C
M19972A
SENSORS MUST BE ARRANGED IN THIS
1
CONFIGURATION TO OPERATE CORRECTLY.
WIRES MUST HAVE A CABLE SEPARATE FROM THE
2
THERMOSTAT CABLE.
Fig. 7. Wiring Multiple C7189U Sensors.
.
Fig. 8. Inside Temperature Reading on TH8000
3
C7189U REMOTE INDOOR SENSOR
M24116
Y2
W2
1
2
1
C7189 C7189
S2
C7189 C7189
Y2
W2
2
1
C7189 C7189
2
C7189 C7189
C7189 C7189
TUE
CHANGE FILTER UV LAMP HUMIDIFIER PAD
FAN
Inside
Set To
AUTO
Heat On
Following
SYSTEM
Schedule
HEAT
AM
SCHED HOLD CLOCK SCREEN MORE
Series Thermostat.
1
C7189
C7189
C7189
M19973
M19974
69-1710EFS—02