Portamate PM-8000 Manual Del Operador página 5

3. Attach top table
a. Unlatch the swing latches "
side assembly
b. Bring inverted top table "
c. Latch the swing latches "
hold table in place
d. Slide the large washers "
table and side frames
e. Insert and tighten M10 allen bolts "
the 10mm allen key provided
4. Attach the handle
a. Combine the handle "
do NOT tighten set screws "
b. Rotate locking knobs "
unlocked position
c. Depress pins "
frame tube
d. The pins " " will snap out behind the locking
knobs " ", rotate locking knobs clockwise to
locked position and push in to depress pins
e. Push the handle "
snap into place, handle is now installed and in
the up position
f. Depress pins "
way into the down position
g. Tighten set screws "
that a small gap will be present between the
two halves of the handle
5. Assembly is complete!
" on each
" into position
" on both sides to
" between the top
" using
" into one piece,
" at this time
" counterclockwise to
" and slide handle " " into
" down and pins " " will
" and push the handle all the
" on handle " ", note
3
Step 3
4
STEP 4
5
5