Portamate PM-8000 Manual Del Operador página 8

Adjusting the height of the material
support table:
1. Loosen the adjusting slide (1a), undo
the screws entirely and set in a safe
place (1b)
2. Pick up the material support table until
it locks in place
3. Place a level or straight edge on the
saw and material supports, push up
or down on material support table
until it is even with the saw
4. Choose the correct slot to place the
screws in
5. Thread screws back into place most
of the way, make any fine adjustments
to the material support height before
tightening them all the way
6. Push orange buttons on adjusting
slide to release the material supports.
Release one side of the table at a
time, then push down to drop it back
into place
1a
2
4
6a
8
1b
3
5
6b