Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Weight: APPROX. 40g
Safety: For indoor use
3. BATTERY INSTALLATION
1. Open the battery door (end cap) by gently pry-
ing up/out at the pocket clip using a small screw-
driver.
2. Insert two AAA batteries (observe polarity).
3. Replace the battery door.
NOTE: If your meter does not work properly,
check the battery to make sure if it is still good
and that it is properly inserted.
To avoid electric shock, do not operate the
meter until the battery cover is in place and
fastened securely.
The measurement must be done only with the
cap on the probe tip.
4. OPERATING INSTRUCTIONS
Risk of Electrocution. High-voltage circuits,
both AC and DC, are very dangerous and
should be measured with great care.
KPS-DT10 • Voltage detector
WARNING
WARNING
WARNING
6
KPS-
5. D
Ris
for
age
tha
Ris
on
pro
To ch
1. To
outle
2. If A
light
Publicidad
Tabla de contenido
