6. Locate the glass door to the designated position making sure that the door shaft enters the door
hole at the left upper corner of the glass door. Install the two screws that are used to connect the left
lower hinge with the glass door and tighten them before the door is leveled. Then remove the handle
from the left side and install it on the right side of the door.
3. OPERATING YOUR WINE COOLER
These wine coolers should be placed in where the ambient temperature is between 16-32°C. If the
ambient temperature is above or below this range, the performance of the unit may be affected. For
example, placing your unit in extreme cold or hot conditions may cause interior temperatures to
fluctuate. The range may not be reached.
➢
Panel control of CVDE46-2
Indicator light illuminates to signify the cooling mode is currently in operation.
To control this appliance, turn ON/OFF (press and hold this button for approximately
2 seconds).
To control the inner light, turn on/off.
Used to set temperature in upper zone.
Used to set temperature in lower zone
26