Refrigerators Transport And Location - EAS ELECTRIC EMSS179AX Manual De Usuario

 Remove all packaging material before using the new refrigerator. This
includes the foam base and all adhesive tape holding the refrigerator
accessories inside and outside.
 Clean both the inside and outside of the refrigerator with wet cloth ( a little
detergent could be added into the warm water to wash the cloth and then
wipe it again witg the clean water).
 Prepare an independent two-pole socket with grounding contact for the
refrigerator and ir shall not share a multi-purpose socket with other
electrical appliances.
 Do connect grounding wire. The grounding pole of the socket shall be
provided with a reliable grounding wire.
 Open the refrigerator body and take out the accessory (decorative cover
for bottom beam) and the two screws from the instruction packaging bag;
then install them into the bottom beam as shown by the schematic diagram
on the right.

4. REFRIGERATORS TRANSPORT AND LOCATION

Transport
Please don't inverted, squeezed, vibration refrigerator when moving. The tilt
angle can't larger than 45 degree.
When moving, don't cling the door or coping.
Location
 Ensure proper air circulation. Don't place the unit heat source, direct
sunlight, moisture or water, avoid rust and weakening the insulation.
 Top space at least 30cm, space on both the sides and back at least
10cm from the wall, so refrigerator door can open or close convenience
and emanate heat.
 Installing the refrigerator on solid, level floor ( If don't level, it can adjust
the leveler to level).
31
V.1